Range Rover: Gearbox
- Automatic transmission
- Commandshift
- Manual gear selection
- Hill descent
- Transfer gearbox
- Stationary range changing
- Range change indicators
- Range changing on the move
- Automatic transmission high to low range
- Changing from low to high range
Rolling re-start
A rolling restart can be initiated by selecting N (neutral) and pressing the
engine START/STOP button. ...
Automatic transmission
1. To select Drive (D) when the vehicle is stationary, apply the foot brake and
press the gear selector release button.
Note: If pressure is applied to the selector lever before the foot brake is ...
See also:
SBZA Detection Zones
The SBZA sensor covers a zone of approximately one lane over from both sides
of the vehicle, 3.5m (11 ft). This zone starts at each side mirror and goes back
approximately 5.0m(16 ft). The height ...
Taillamps, Turn Signal, Sidemarker, and Stoplamps
A. Taillamp
B. Sidemarker Lamp
To replace one of these bulbs:
1. Open the liftgate. See Liftgate .
2. Remove the black cuff from the lamp assembly by pulling rearward from the top
to unfasten ...
Power Door Locks
Press or
on the RKE transmitter. See Remote
Keyless Entry (RKE) System Operation .
: Press to lock the doors.
: Press to unlock the doors.
See Door Locks . ...






