Mercedes-Benz GL-Class: Driving on sand - Off-road driving - Driving tips - Driving and parking - Mercedes-Benz GL-Class Owner's ManualMercedes-Benz GL-Class: Driving on sand

WARNING Do not reduce the tire inflation pressure 
Do not reduce the tire inflation pressure before driving through sand. However, if you do so, remember to correct the tire inflation pressure before continuing your trip. Driving with reduced tire inflation pressure increases the risk of losing control of the vehicle and rolling over.

Observe the following rules when driving on sand:

select a higher vehicle level.
avoid high engine speeds.
select a shift range appropriate to the terrain.
drive quickly to overcome the rolling resistance. Otherwise, the vehicle could dig itself into the sand.
drive in the tracks of other vehicles if possible. Make sure that the ruts are not too deep, that the sand is firm enough and that your vehicle has sufficient ground clearance.

    Checklist after driving off-road
    WARNING   If you notice sudden significant vibrations or unusual handling performance or if you suspect that damage has occurred to the vehicle, you should activate the hazard warning l ...

    Ruts and gravel roads
    Observe the following rules when driving along ruts in off-road terrain or on roads with loose gravel: Check that the ruts are not too deep and that your vehicle has sufficient clearance. O ...

    See also:

    Rock crawl
    This program should be used for terrain which is predominantly rocky, including for crossing river beds with submerged rocks. This program provides good low-speed control. Rock crawl can only be ...

    Voice settings
    • Command list: View the categories and the acceptable voice commands. Select an Information button to view alternative function commands. • Voicetags: View the categories. Select a catego ...

    How to select menus on the screen
    Vehicle functions are viewed on the display screen in menus. To select each key item, highlight the preferred item using the INFINITI controller and push the ENTER button. Whenever a menu ...