Range Rover: Changing the follow mode set gap
Four gap settings are available. The selected gap setting is displayed on the message center when the gap adjustment buttons are operated.
Each gap level is indicated by an additional chevron in front of the vehicle icon in the message center. After the ignition is switched on, the default gap (gap level 3) will be automatically selected ready for ACC operation.
Note: It is the driver’s responsibility to select a gap appropriate to the driving conditions.
Entering follow mode
WARNING
When in follow mode, the vehicle will not decelerate automatically to a stop,
nor will the vehicle always decelerate quickly enough to avoid a collision.
Note: Follow mode is an integ ...
Overriding the speed and follow mode
Whenever the driver is overriding the ACC by depressing the accelerator pedal,
the ACC will not automatically apply the brakes to maintain separation from any
vehicle ahead.
The set speed and gap ...
See also:
If the Off Indicator is Lit for an Adult-Size Occupant
If a person of adult size is sitting in the right front passenger seat, but the
off indicator is lit, it could be because that person is not sitting properly in
the seat. If this happens, use the ...
Adjusting the seats
Vehicles without Memory function: the
seats can be adjusted within three minutes
of a front door being opened.
The time period starts over again if, within
these three minutes, you:
• open o ...
Activating the rear view camera
► Make sure that the SmartKey is in
position
2 in the ignition lock.
► Make sure that the "rear view camera"
function is selected in COMAND (see the
separate operating inst ...
