Buick Enclave: California Fuel Requirements - Fuel - Driving and Operating - Buick Enclave Owner's ManualBuick Enclave: California Fuel Requirements

If the vehicle is certified to meet California Emissions Standards, it is designed to operate on fuels that meet California specifications.

See the underhood emission control label. If this fuel is not available in states adopting California Emissions Standards, the vehicle will operate satisfactorily on fuels meeting federal specifications, but emission control system performance might be affected. The malfunction indicator lamp could turn on and the vehicle might fail a smog-check test.

See Malfunction Indicator Lamp . If this occurs, return to your authorized dealer for diagnosis.

If it is determined that the condition is caused by the type of fuel used, repairs might not be covered by the vehicle warranty.

    Gasoline Specifications (U.S. and Canada Only)
    At a minimum, gasoline should meet ASTM specification D 4814 in the United States or CAN/CGSB-3.5 or 3.511 in Canada. Some gasolines contain an octane-enhancing additive called methylcyclopentadie ...

    Fuels in Foreign Countries
    Never use leaded gasoline or any other fuel not recommended in the previous text on fuel. Costly repairs caused by use of improper fuel would not be covered by the vehicle warranty. To check the ...

    See also:

    Active Fuel Management®
    Vehicles with V8 engines may have Active Fuel Management™. This system allows the engine to operate on either all or half of its cylinders, depending on the driving conditions. When less power is ...

    Overview: changing bulbs/bulb types
    You can change the following bulbs. The bulb type can be found in the legend. Halogen headlamps 1 Low-beam headlamp: H7 55 W 2 High-beam headlamp: H7 55 W 3 Parking lamp/standing lamp: W 5 W 4 ...

    Rear towing point
    The rear towing point is located behind a removal panel in the lower rear bumper. The rear towing point may be used to tow another vehicle if required. 1. Rotate each of the fasteners 90 degrees ...