Range Rover: Wheel changing - Wheel changing - Range Rover Owner's ManualRange Rover: Wheel changing

1. Read and observe the warnings in Wheel changing safety.
2. Before raising the vehicle, use the wheel nut brace to slacken the wheel nuts half a turn counter-clockwise.
3. Position the jack under the relevant jacking point under the chassis.
4. Turn the jack lever clockwise to raise the jack cradle until it engages with the jacking point. Ensure that the base of the jack is in full contact with the road surface.
5. Raise the vehicle using the jack with a slow steady operation. Avoid rapid, jerky actions as they may cause the vehicle/jack to become unstable.
6. Remove the wheel nuts and place them together where they cannot roll away.
7. Remove the wheel and place to one side. Do not lay the wheel on its face, as this may damage the finish.
8. Fit the spare wheel to the hub.
9. Re-fit the wheel nuts, and lightly tighten them. Ensure that the wheel is making contact with the hub evenly.
10. Ensure that the space under the vehicle is clear of obstructions, and lower the vehicle slowly and smoothly.
11. With all wheels on the ground and the jack removed, fully tighten the wheel nuts. The wheel nuts must be tightened in sequence (see illustration) to the correct torque of 98 lbf.ft (133 Nm).

Note: If it is not possible to torque the wheel nuts when a wheel is replaced,

Note: If it is not possible to torque the wheel nuts when a wheel is replaced, they should be set to the correct torque as soon as possible.

If an alloy spare wheel is to be fitted, using a suitable blunt tool, knock the center cap out of the removed wheel. Using hand pressure only, press the center cap into the newly fitted spare.

Check and adjust the tire pressure as soon as possible.

    Operating the jack
    1. Locate the jack under the recommended jacking point. 2. Attach the cranking lever to the jack using the adaptor. Fit the wheel nut brace to the end of the cranking lever and rotate clockwise t ...

    Important – use of spare tire
    WARNING Adhere to the instructions on the temporary spare warning label, affixed to the wheel. Where fitted the temporary use spare wheel is FOR TEMPORARY USE ONLY. Drive with caution while ...

    See also:

    Cleaning
    If your windshield is not clear after using the windshield washer or if a wiper blade chatters when running, wax or other material may be on the blade or windshield. Clean the outside of the w ...

    Battery Voltage and Charging Messages
    BATTERY LOW START VEHICLE When the vehicle’s battery is severely discharged, this message will display and four chimes will sound. Start the vehicle immediately. If the vehicle is not started and ...

    Replacing the Engine Air Cleaner/ Filter
    1. Locate the air cleaner/filter assembly. See Engine Compartment Overview  . 2. Loosen the four screws on the cover of the housing and lift up the cover. 3. Remove the engine air cleaner/ ...