How to Check Lubricant

To get an accurate reading, the vehicle should be on a level surface. For Two-Wheel-Drive vehicles, the proper level is from 15mm to 40mm (0.6 in to 1.6 in) below the bottom of the filler plug ...

Starter Switch Check

WARNING When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured. 1. Before starting this check, be sure there is enough room ar ...

See also:

Brake fluid
For further brake fluid specification information, see “Capacities and recommended fuel/lubricants” in the “9. Technical and consumer information” section of this manual. WARNING & ...

Using the 3.5mm (1/8 in) Auxiliary Input Jack
The auxiliary input jack is located on the lower right side of the faceplate. This is not an audio output; do not plug a headphone set into the front auxiliary input jack. Connect an auxiliary inpu ...

Grass/gravel/snow
This program should be used where a firm surface is covered with loose or slippery material. Note: For deep gravel it is recommended that the Sand program is selected. Note: If the vehicle is un ...