Cadillac Escalade: Universal Remote System Operation
Press and hold the appropriate button for at least half of a second. The indicator light will come on while the signal is being transmitted.
Reprogramming Universal Home Remote Buttons
Any of the three buttons can be reprogrammed by repeating the instructions.
Erasing Universal Home Remote Buttons
The programmed buttons should be erased when the vehicle is sold or the lease ends.
To erase either Rolling Code or Fixed Code settings on the Universal Home Remote device:
1. Press and hold the two outside buttons at the same time for approximately 20 seconds, until the indicator lights, located directly above the buttons, begin to blink rapidly.
2. Once the indicator lights begin to blink, release both buttons. The codes from all buttons will be erased.
For help or information on the Universal Home Remote System, call the customer assistance phone number under Customer Assistance Offices (U.S. and Canada) or Customer Assistance Offices (Mexico) .
Programming Universal Home Remote — Fixed Code
For questions or help programming the Universal Home Remote System, call 1-866-572-2728
or go to www.learcar2u.com.
Most garage door openers sold before 1996 are Fixed Code units.
Programming a gar ...
Lighting
...
See also:
Lower Anchors and Tethers for CHildren System (LATCH)
LATCH system lower anchor locations -
captain’s seats
LATCH system lower anchor locations -
bench seat
Your vehicle is equipped with special
anchor points that are used with the LA ...
Side Blind Zone Alert (SBZA)
If available, this feature will alert you to vehicles located in the vehicle's
side blind zone. When the system detects a vehicle in the side blind zone, the SBZA
display will light up in the co ...
Restricted seat travel
NOTICE
If seat movement stops unexpectedly during adjustment, check for and remove any
obstructions.
Once any obstructions have been removed, the seat adjustment mechanism can be
reset as f ...