Buick Enclave: Universal Remote System Operation
Using Universal Remote
Press and hold the appropriate Universal Remote button for at least half of a second. The indicator light will come on while the signal is being transmitted.
Erasing Universal Remote Buttons
All programmed buttons should be erased when the vehicle is sold or the lease ends.
To erase all programmed buttons on the Universal Remote device:
1. Press and hold down the two outside buttons until the indicator light begins
to flash, after 20 seconds.
2. Release both buttons.
Reprogramming a Single Universal Remote Button
To reprogram any of the three Universal Remote buttons, repeat the programming instructions earlier in this section, beginning with Step 2.
For help or information on the Universal Home Remote System, call the customer assistance phone number under Customer Assistance Offices (U.S. and Canada) or Customer Assistance Offices (Mexico) .
Universal Remote System Programming
This system provides a way to replace up to three remote control transmitters
used to activate devices such as garage door openers, security systems, and home
automation devices.
Do not use the ...
Lighting
...
See also:
Precautions on vehicle-to-vehicle distance control mode
The system is intended to enhance the
operation of the vehicle when following a
vehicle traveling in the same lane and
direction.
If the distance sensor A detects a slower
moving vehicle a ...
Fuel
Use of the recommended fuel is an important part of the proper maintenance of
this vehicle. To help keep the engine clean and maintain optimum vehicle performance,
we recommend the use of gasoline ...
Bluetooth® information
Bluetooth® is the name for short-range radio frequency (RF) technology that allows
electronic devices to communicate wirelessly with each other.
The Land Rover Bluetooth® system supports Blueto ...
