Mercedes-Benz GL-Class: Tire pressure of at least 180 kPa(1.8 bar/26 psi) is not reached
If, after five minutes, a pressure of 180 kPa (1.8 bar/26 psi) has not been achieved:
► Press the on/off switch on the tire inflation compressor to 0.
The tire inflation compressor is switched off.
► Unscrew the filler hose from the valve of
the faulty tire.
► Very slowly drive forwards or reverse
approximately 30 ft (10 m).
► Pump up the tire again.
WARNING
If after five minutes a pressure of 180 kPa
(1.8 bar/26 psi) cannot be achieved, the tire
is too badly damaged to be repaired reliably
using TIREFIT.
In this case TIREFIT cannot seal the tire
properly.
Do not drive any further.
Contact the nearest authorized Mercedes-Benz Center for assistance or call
Roadside
Assistance.
TIREFIT kit version 2
► Pull connector 4 with the cable and hose 5 out of the housing. ► Screw hose 5 onto flange 6 of tire sealant bottle 1. ► Insert tire sealant bottle 1 head downwards into re ...Tire pressure of 180 kPa (1.8 bar/26 psi) is reached
► Press the on/off switch on the tire inflation compressor to 0. The tire inflation compressor is switched off. ► Unscrew the filler hose from the valve of the faulty tire. ...See also:
NECK-PRO head restraints
Resetting the NECK-PRO head restraints
requires a lot of strength. If you have
difficulty resetting the NECK-PRO head
restraints, have this work carried out at a qualified specialist workshop, e.g ...
Child restraint check list
Every time a child travels in the vehicle observe the following:-
Non-LATCH child restraints
• Carefully follow the instructions provided by the manufacturer of the
restraint system.
• A ...
Forward-facing child restraint installation using LATCH
Refer to all Warnings and Cautions in the
“Child safety” and “Child restraints” sections
before installing a child restraint.
Follow these steps to install a forwardfacing
child restra ...