Cadillac Escalade: Testing the Alarm
To test the alarm:
1. From inside the vehicle, lower the driver window and open the driver door.
2. Activate the system by locking the doors with the power door lock switch while the door is open, or with the RKE transmitter.
3. Get out of the vehicle, close the door and wait for the security light to go out.
4. Then reach in through the window, unlock the door with the manual door lock and open the door. This should set off the alarm.
While the alarm is set, the power door unlock switch will not work. If the alarm does not sound when it should but the headlamps flash, check to see if the horn works. The horn fuse may be blown. To replace the fuse, see Fuses and Circuit Breakers .
If the alarm does not sound or the headlamps do not flash, the vehicle should be serviced by your dealer.
Anti-theft Alarm System
Your vehicle has a content theft-deterrent alarm system.
This is the security light.
To arm the theft-deterrent system:
1. Open the door.
2. Lock the door with the Remote Keyless Entry (RKE) tra ...
Immobilizer
See Radio Frequency Statement for information regarding Part 15
of the Federal Communications Commission (FCC) rules and Industry Canada Standards
RSS-GEN/210/220/310. ...
See also:
Using snow chains
WARNING
Only use traction devices in heavy snow conditions, on hard road surfaces.
Dynamic Stability Control (DSC) must be switched off when using traction devices.
Never exceed 30 mph (50 km/ ...
Anti-theft Alarm System
On vehicles with an anti-theft alarm system, to activate the system:
► Press on the Remote Keyless Entry
(RKE) transmitter or the power door lock switch when any door is open.
The securit ...
Search area
The navigation map database is divided into countries, or geographically defined
areas within countries, that the navigation system recognises as search areas. When
setting a route, the destinatio ...