Mercedes-Benz GL-Class: SRS warning lamps
SRS functions are checked regularly when you switch on the ignition and when the engine is running. Therefore, malfunctions can be detected in good time.
The SRS warning lamp in the
instrument
cluster lights up when the ignition is switched on. It goes out no later than a
few seconds
after the engine is started.
The SRS components are in operational
readiness when the SRS warning lamp
is not lit while the engine is running .
WARNING
The SRS self-check has detected a
malfunction if the SRS
warning lamp:
• does not come on at all
• fails to go out approximately 4
seconds
after the engine was started
• comes on after the engine was
started or
while driving
For your safety, Mercedes-Benz strongly
recommends that you have the system
checked as soon as possible at an authorized
Mercedes-Benz Center. Otherwise the SRS
may not be activated when it is needed in an
accident, which could result in serious or fatal
injury. The SRS might also deploy
unexpectedly and unnecessarily which could
also result in injury.
In addition, improper work on the SRS creates
a risk of rendering the SRS inoperative or
causing unintended air bag deployment. Work
on the SRS must therefore only be performed
by qualified technicians. Contact an
authorized Mercedes-Benz Center.
If it is necessary to modify an air bag system
to accommodate a person with disabilities,
contact an authorized Mercedes-Benz Center
for details. USA only: Call our Customer
Assistance Center at 1-800-FOR-MERCedes
(1-800-367-6372) for details.
Introduction
SRS consists of:
• the
SRS warning lamp
• air bags
• air bag control unit (with crash sensors)
• Emergency Tensioning Devices/belt
buckle tensioners
• belt force limiters
SRS redu ...
Safety guidelines for seat belts,Emergency Tensioning Devices (ETDs)and air bags
WARNING
• Damaged seat belts or seat belts
that have
been subjected to stress in an accident
must be replaced. Their anchoring points
must also be checked. Only use seat belts inst ...
See also:
Radio Frequency Identification (RFID)
RFID technology is used in some vehicles for functions such as tire pressure
monitoring and ignition system security, as well as in connection with conveniences
such as key fobs for remote door lock ...
Dome Lamps
The dome lamps are located in the overhead console.
They come on when any door is opened and turn off after all the doors are closed.
Turn the instrument panel brightness knob located below the dome ...
Tire pressure of at least 180 kPa(1.8 bar/26 psi) is not reached
If, after five minutes, a pressure of 180 kPa
(1.8 bar/26 psi) has not been achieved:
► Press the on/off switch on the tire
inflation
compressor to 0.
The tire inflation compressor is ...