Infiniti QX: Reprogramming a single HomeLink® button
To reprogram a HomeLink® Universal Transceiver button, complete the following. 1. Push and hold the desired HomeLink® button. Do not release the button until step 4 has been completed. 2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 2 to 5 in (50 to 127 mm) away from the HomeLink® surface. 3. Push and hold the hand-held transmitter button. 4. The HomeLink® indicator light will flash, first slowly and then rapidly. When the indicator light begins to flash rapidly, release both buttons. The HomeLink® Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLink® button that was just programmed. This procedure will not affect any other programmed HomeLink® buttons.
Clearing the programmed information
Individual buttons cannot be cleared,
however to clear all programming, push
and hold the two outside buttons and
release when the indicator light begins to
flash (in approximately 20 seconds) ...
If your vehicle is stolen
If your vehicle is stolen, you should change
the codes of any non-rolling code device
that has been programmed into
HomeLink®. Consult the Owner’s Manual
of each device or call the manufact ...
See also:
Power Reclining Seatbacks
To adjust the seatback:
Tilt the top of the control rearward to recline.
Tilt the top of the control forward to raise.
WARNING
Sitting in a reclined position when the vehicle is in mot ...
Sunroof
The ignition must be in ON/RUN or ACC/ACCESSORY to operate the sunroof and power
sunshade.
See Retained Accessory Power (RAP) .
The vehicle may have a sunroof over the front seats and a rear sunro ...
Resetting to factory settings
For safety reasons, the Daytime Running
Lamps function in the Lighting submenu is
only reset when the engine is switched off.
► Press
on the steering wheel
to select the Settings menu.
...
