Range Rover: Reprograming a single garage door opener button
To program a device to a previously programed button:
1. Press and hold the desired pre-programed garage door opener button for at least 20 seconds, but no longer than 30 seconds, until the indicator lamp begins to flash.
2. Without releasing the rear-view mirror button, position the hand-held transmitter approximately 2 to 6 inches (50 to 150 mm) away from the transceiver in the rear-view mirror, keeping the indicator lamp in view.
3. Carry out Step 3 of Programing.
Rolling code device equipment programing
Note: The assistance of a second person, may make the following steps quicker and easier. Once the button has been pressed there are only 30 seconds in which to complete Step 3. 1. At the garage ...Entry gate/canadian programing
The technology of some entry gates requires you to press and re-press (cycle) the hand-held transmitter button every two seconds during programing. Continue to press and hold the desired rear-view ...See also:
Key and Lock Messages
REPLACE BATTERY IN REMOTE KEY
This message displays if a Remote Keyless Entry (RKE) transmitter battery is
low. The battery needs to be replaced in the transmitter.
See “Battery Replacement” u ...
4ETS (Electronic Traction System)
Observe the "Important safety notes"
section.
Traction control is part of ESP®.
Traction control brakes the drive wheels
individually if they spin. This enables you to
pull away and ...
Driving on Hills
Driving safely on hills requires good judgment and an understanding of what the
vehicle can and cannot do.
WARNING
Many hills are simply too steep for any vehicle. Driving up hills can cause th ...