Mercedes-Benz GL-Class: Releasing seat belts
► Press release button 4 and guide belt tongue 2 back towards belt sash guide 1.
Make sure that the seat belt is fully rolled
up. Otherwise, the seat belt or belt tongue
will be trapped in the door or in the seat
mechanism. This could damage the door,
the door trim panel and the seat belt.
Damaged seat belts can no longer fulfill their protective function and must be replaced. Consult an authorized Mercedes- Benz Center.
Belt height adjustment
You can adjust the seat belt height on the
driver's seat and the front-passenger seat.
Adjust the height so that the upper part of the
seat belt is routed across the center of your
shoulder.
...
Belt warning for the driver and frontpassenger
Regardless of whether the driver and front
passenger have fastened their seat belts
already, the seat belt warning lamp
lights up for 6 seconds after every engine
start. It then goes out if the d ...
See also:
Adding Washer Fluid
The vehicle has a low washer fluid message on the DIC that comes on when the
washer fluid is low. The message is displayed for 15 seconds at the start of each
ignition cycle. When the WASHER FLUID L ...
Exterior Lamps Off Reminder
If a door is open, a reminder chime sounds when the headlamps or parking lamps
are manually turned on and the key is out of the ignition. To turn off the chime,
turn the headlamp switch to off or AU ...
Two-Wheel-Drive Vehicles
Dinghy Towing
Notice: If a two-wheel-drive vehicle is towed with all four wheels on the ground,
the transmission could be damaged. The repairs would not be covered by the vehicle
warranty. Do not ...






