Infiniti QX: Precautions on vehicle-to-vehicle distance control mode - Intelligent Cruise Control (ICC) system (if so equipped) - Starting and driving - Infiniti QX Owner's ManualInfiniti QX: Precautions on vehicle-to-vehicle distance control mode

The system is intended to enhance the

The system is intended to enhance the operation of the vehicle when following a vehicle traveling in the same lane and direction. If the distance sensor A detects a slower moving vehicle ahead, the system will reduce the vehicle speed so that your vehicle follows the vehicle in front at the selected distance. The system automatically controls the throttle and applies the brakes (up to 25% of vehicle braking power) if necessary. The detection range of the sensor is approximately 390 ft (120 m) ahead.

► This system is only an aid to assist the WARNING

► This system is only an aid to assist the driver and is not a collision warning or avoidance device. It is the driver’s responsibility to stay alert, drive safely and be in control of the vehicle at all times.
► The system is primarily intended for use on straight, dry, open roads with light traffic. It is not advisable to use the system in city traffic or congested areas.
► This system will not adapt automatically to road conditions. This system should be used in evenly flowing traffic. Do not use the system on roads with sharp curves, or on icy roads, in heavy rain or in fog.

The distance sensor will not detect the following objects:
► Stationary and slow moving vehicles
► Pedestrians or objects in the roadway
► Oncoming vehicles in the same lane
► Motorcycles traveling offset in the travel lane

► As there is a performance limit to the WARNING

► As there is a performance limit to the distance control function, never rely solely on the Intelligent Cruise Control (ICC) system. This system does not correct careless, inattentive or absentminded driving, or overcome poor visibility in rain, fog, or other bad weather. Decelerate the vehicle speed by depressing the brake pedal, depending on the distance to the vehicle ahead and the surrounding circumstances in order to maintain a safe distance between vehicles.
► If the vehicle ahead comes to a stop, the vehicle decelerates to a standstill within the limitations of the system. The system will cancel once it judges that the vehicle has come to a standstill and sound a warning chime. To prevent the vehicle from moving, the driver must depress the brake pedal.
► The system may not function properly under the following conditions. To avoid accidents, never use the ICC system under the following conditions: — On roads where the traffic is heavy or there are sharp curves
— On slippery road surfaces such as on ice or snow, etc.
— On off-road surfaces such as on sand or rock, etc.
— During bad weather (rain, fog, snow, etc.).
— When the windshield wipers are operating at high speed. The system may cancel when the wipers are set to the AUTO position.
— When strong light (for example, at sunrise or sunset) is directly shining on the front of the vehicle
— When rain, snow or dirt adhere to the system sensor
— On steep downhill roads (the vehicle may go beyond the set vehicle speed and frequent braking may result in overheating the brakes)
— On repeated uphill and downhill roads
— When traffic conditions make it difficult to keep a proper distance between vehicles because of frequent acceleration or deceleration
— When towing a trailer or other vehicle

► In some road or traffic conditions, a vehicle or object can unexpectedly come into the sensor detection zone and cause automatic braking. You may need to control the distance from other vehicles using the accelerator pedal. Always stay alert and avoid using the ICC system when it is not recommended in this section.

    Vehicle-to-vehicle distance control mode
    In the vehicle-to-vehicle distance control mode, the Intelligent Cruise Control (ICC) system automatically maintains a selected distance from the vehicle traveling in front of you according to ...

    Vehicle-to-vehicle distance control mode operation
    Always pay attention to the operation of the vehicle and be ready to manually control the proper following distance. The vehicle-to-vehicle distance control mode of the Intelligent Cruise Co ...

    See also:

    Testing the Alarm
    To test the alarm: 1. From inside the vehicle, lower the driver window and open the driver door. 2. Activate the system by locking the doors with the power door lock switch while the door is open, ...

    Cleaning the Components
    Use care when touching or cleaning the components such as the DVD player or the discs. Do not use DVD lens cleaners for DVD players because the lens of the DVD optics can become contaminated by lub ...

    Switching the windshield wipers on/off
    WARNING   Wiper blades are components that are subject to wear and tear. Replace the wiper blades twice a year, preferably in the spring and fall. Otherwise the windows will not be wiped ...