Cadillac Escalade: Parking on Hills - Driving Characteristics and Towing Tips - Towing - Driving and Operating - Cadillac Escalade Owner's ManualCadillac Escalade: Parking on Hills

WARNING WARNING

Parking the vehicle on a hill with the trailer attached can be dangerous. If something goes wrong, the rig could start to move. People can be injured, and both the vehicle and the trailer can be damaged. When possible, always park the rig on a flat surface.

If parking the rig on a hill:

1. Press the brake pedal, but do not shift into P (Park) yet. Turn the wheels into the curb if facing downhill or into traffic if facing uphill.

2. Have someone place chocks under the trailer wheels.

3. When the wheel chocks are in place, release the regular brakes until the chocks absorb the load.

4. Reapply the brake pedal. Then apply the parking brake and shift into P (Park).

5. Release the brake pedal.

WARNING WARNING

It can be dangerous to get out of the vehicle if the shift lever is not fully in P (Park) with the parking brake firmly set. The vehicle can roll.

If the engine has been left running, the vehicle can move suddenly. You or others could be injured. To be sure the vehicle will not move, even when on fairly level ground, always put the shift lever fully in P (Park) with the parking brake firmly set.

    Driving on Grades
    Reduce speed and shift to a lower gear before starting down a long or steep downgrade. If the transmission is not shifted down, the brakes might get hot and no longer work well. Vehicles can tow in ...

    Leaving After Parking on a Hill
    1. Apply and hold the brake pedal. 2. Start the engine. 3. Shift into a gear. 4. Release the parking brake. 5. Let up on the brake pedal. 6. Drive slowly until the trailer is clear of the chocks. ...

    See also:

    Seat Adjustment
    To adjust the seat: Move the seat forward or rearward by sliding the control forward or rearward. Raise or lower the front or rear part of the seat cushion by moving the front or rear of the ...

    Switching DSC ON
    DSC is re-enabled by one of the following: • Press and briefly hold the DSC OFF switch. • Start the engine. • Select a new Terrain response special program. ...

    Fuses and Circuit Breakers
    If the vehicle is a hybrid, see the hybrid supplement for more information. The wiring circuits in the vehicle are protected from short circuits by a combination of fuses, circuit breakers and fusib ...