Range Rover: Overriding the speed and follow mode
Whenever the driver is overriding the ACC by depressing the accelerator pedal, the ACC will not automatically apply the brakes to maintain separation from any vehicle ahead.
The set speed and gap can be overridden by pressing the accelerator pedal when cruising at constant speed or in follow mode. If the vehicle is in follow mode, the warning lamp will go out when the ACC is overridden by the driver using the accelerator and CRUISE OVERRIDE will be displayed on the message center. When the accelerator is released the ACC function will operate again and vehicle speed will decrease to the set speed, or a lower speed if follow mode is active.
Changing the follow mode set gap
Four gap settings are available. The selected gap setting is displayed on the message center when the gap adjustment buttons are operated. Each gap level is indicated by an additional chevron in fr ...Automatic low speed switch-OFF
If the speed of the vehicle decreases below 18 mph (30 km/h), the ACC system will be automatically switched off and the warning lamp will go out. If the brakes were being applied by the ACC system, ...See also:
Opening the fuel-filler door
To open the fuel-filler door, unlock the fuelfiller
door by using one of the following
operations, then push the right side of the
door.
► Push the driver’s door handle request
swi ...
Engine compartment
CAUTION
Never use a fuse of a higher or lower
amperage rating than that specified on the
fuse box cover. This could damage the
electrical system or cause a fire.
If any electrical equipme ...
Reclining Seatbacks
Power Reclining Seatbacks
WARNING
You can lose control of the vehicle if you try to adjust the seat while the vehicle
is moving.
The sudden movement could startle and confuse you, or make you pus ...