Cadillac Escalade: Instrument Panel, Leather, Vinyl, and Other Plastic Surfaces
Use a soft microfiber cloth dampened with water to remove dust and loose dirt. For a more thorough cleaning, use a soft microfiber cloth dampened with a mild soap solution.
Notice: Soaking or saturating leather, especially perforated leather, as well as other interior surfaces, may cause permanent damage. Wipe excess moisture from these surfaces after cleaning and allow them to dry naturally. Never use heat, steam, spot lifters or spot removers. Do not use cleaners that contain silicone or wax-based products. Cleaners containing these solvents can permanently change the appearance and feel of leather or soft trim and are not recommended.
Do not use cleaners that increase gloss, especially on the instrument panel. Reflected glare can decrease visibility through the windshield under certain conditions.
Notice: Use of air fresheners may cause permanent damage to plastics and painted surfaces. If an air freshener comes in contact with any plastic or painted surface in the vehicle, blot immediately and clean with a soft cloth dampened with a mild soap solution. Damage caused by air fresheners would not be covered by the vehicle warranty.
TEHAMA™ Leather
The leather surface on the seat was not designed to be aggressively cleaned using
any commercial product. Use a well wrung cloth dampened with water to remove dust.
Do not use a wet cloth or saturat ...
Speaker Covers
Vacuum around a speaker cover gently, so that the speaker will not be damaged.
Clean spots with just water and mild soap. ...
See also:
Trailer guidance
Note: Trailer guidance requires a connected trailer to be fitted with a tracking
target sticker, which must be attached according to specific instructions. Ask your
Land Rover Retailer/Authorized ...
Time/date
This submenu is only available on vehicles
with no navigation module. To set the time
and the date for vehicles with a navigation
module, see the separate operating
instructions.
In the Time/da ...
Headlamp removal
WARNING
Do not attempt to change any bulb with the lighting switch on. If the lighting
has just been switched off, give the bulbs time to cool down. Handling them in a
hot conditio ...






