Cadillac Escalade: Installing the Third Row Seat
To install the seat:
1. Open the liftgate to access the rear of the vehicle.
2. Slide the front outboard seat wheels into the track on the floor and roll the seat forward. The front latches should lock into place. If the latches do not lock, try tilting the rear of the seat upward slightly.
3. Lower the rear of the seat and push down on the seat to engage the rear floor latches.
WARNING
A seat that is not locked into place properly can move around in a collision or sudden stop. People in the vehicle could be injured. Be sure to lock the seat into place properly when installing it.
4. Push and pull on the seat to make sure it is locked into place. The seatback cannot be raised to the upright position unless the seat is latched to the floor.
5. Raise the seatback to the upright position.
6. Push and pull on the seatback to make sure it is locked.
7. Make sure the safety belts are returned to the original position over the seatbacks.
Removing the Third Row Seat
To remove the seat:
1. Open the liftgate to access the controls for the seat.
2. Fold the seatbacks forward using lever “1” and the instructions listed previously
under “Folding the Seatback. ...
Safety Belts
...
See also:
Intelligent Key battery replacement
CAUTION
Be careful not to allow children to swallow
the battery and removed parts.
Replace the battery as follows:
1. Release the lock knob at the back of the
Intelligent Key and remove t ...
Cleaning the wheels
Do not use acidic wheel cleaning products
to remove brake dust. This could damage
wheel bolts and brake components.
Do not park the vehicle for an extended
period straight after cleaning it, ...
License Plate Lamp
1. Remove the two screws holding each of the license plate lamps to the molding
that is part of the liftgate.
2. Twist and pull the license plate lamp assembly forward through the molding
opening ...