Mercedes-Benz GL-Class: Indicator and warning display - Blind Spot Assist - Driving systems - Driving and parking - Mercedes-Benz GL-Class Owner's ManualMercedes-Benz GL-Class: Indicator and warning display

1 Yellow indicator lamp/red warning lamp

1 Yellow indicator lamp/red warning lamp

When Blind Spot Assist is activated, indicator lamp 1 lights up yellow in the exterior mirrors up to a vehicle speed of 20 mph (30 km/h). When the vehicle speed exceeds 20 mph (30 km/h), the indicator lamp goes out and Blind Spot Assist is ready for use.

When your speed exceeds approximately 20 mph (30 km/h), warning lamp 1 lights up red on the corresponding side whenever a vehicle is detected in the blind spot monitoring range. This warning is always given when a vehicle enters the blind spot monitoring range from behind or from the side. When you are passing another vehicle, the warning is emitted only if the difference in speed is less than 7 mph (12 km/h).

The yellow indicator lamp goes out if the reverse gear is engaged. In this event, Blind Spot Assist is no longer active.

The brightness of the indicator/warning lamps is adjusted automatically according to the ambient light.

WARNING Blind Spot Assist is not active at speeds under 
Blind Spot Assist is not active at speeds under approximately 20 mph (30 km/h). The indicator lamps in the exterior mirrors are yellow. Vehicles in the monitoring range are then not indicated.
Always pay attention to traffic conditions and your surroundings. Otherwise, you may fail to recognize dangers in time, cause an accident and injure yourself and others.

    Monitoring range of the sensors
    Blind Spot Assist monitors the area shown in the figure up to 10 ft (3 m) behind and immediately adjacent to your vehicle. WARNING   Blind Spot Assist monitors certain areas in the im ...

    Collision warning
    If a vehicle is detected in the monitoring range of Blind Spot Assist and you switch on the turn signal, a double warning tone sounds. Red warning lamp 1 flashes. If the turn signal remains on, de ...

    See also:

    Trailer towing
    PARKTRONIC is deactivated for the rear area when you establish an electrical connection between your vehicle and a trailer. Fold in the ball coupling if the trailer tow hitch is not required. ...

    Setting the airflow
    ► Turn the SmartKey to position 2 in the ignition lock. ► To increase/reduce: press the button. Vehicles with Voice Control System: when the Voice Control System is switched on, the ...

    Video media inhibit with vehicle moving
    When the vehicle is moving the video picture will automatically be inhibited. The touch screen will display the TV/My video screen and the relevant safety message will be displayed. ...