Buick Enclave: Engine Oil Messages - Information Displays - Instruments and Controls - Buick Enclave Owner's ManualBuick Enclave: Engine Oil Messages

CHANGE ENGINE OIL SOON

This message displays when the engine oil needs to be changed.

When you change the engine oil, be sure to reset the CHANGE ENGINE OIL SOON message. See Engine Oil Life System  for information on how to reset the message. See Engine Oil  and Maintenance Schedule  for more information.

OIL PRESSURE LOW STOP ENGINE

Notice: If you drive the vehicle while the engine oil pressure is low, severe engine damage may occur. If a low oil pressure warning appears on the instrument panel cluster and/or DIC, stop the vehicle as soon as possible. Do not drive the vehicle until the cause of the low oil pressure is corrected.

See Engine Oil  for more information.

This message displays if low oil pressure levels occur. Stop the vehicle as soon as safely possible and do not operate it until the cause of the low oil pressure has been corrected. Check the oil as soon as possible and have your vehicle serviced by your dealer. See Engine Oil

    Engine Cooling System Messages
    ENGINE HOT A/C (Air Conditioning) OFF This message displays when the engine coolant becomes hotter than the normal operating temperature. See Engine Coolant Temperature Gauge . To avoid added stra ...

    Engine Power Mes
    ENGINE POWER IS REDUCED This message displays and a chime sounds when the cooling system temperature gets too hot and the engine further enters the engine coolant protection mode. See Engine Overh ...

    See also:

    Fuel gauge
    The gauge indicates the approximate fuel level in the tank. The gauge may move slightly during braking, turning, acceleration, or going up or down hills. The gauge needle returns to 0 (Emp ...

    Older Children
    Older children who have outgrown booster seats should wear the vehicle safety belts. The manufacturer's instructions that come with the booster seat state the weight and height limitations fo ...

    Stationary range changing
    With the vehicle stationary, select N. Move the transfer gearbox switch towards the range required and release. The switch returns to the default position and range change status will be confirmed ...