Range Rover: Commandshift
If CommandShift™ is selected in high range, gears 1 or 2 may be used for moving off from stationary. In low range, gears 1, 2 or 3 may be used, which may prove useful in certain off-road driving conditions.
TRANSMISSION COMMANDSHIFT SELECTED
will appear in the message center when the transmission is in CommandShift™ mode.
Note: In order to protect the engine, the transmission will automatically change up to prevent over-revving, or down if the engine is laboring.
NOTICE
Make sure you do not over-rev the engine when using CommandShift™ on vehicles with the Terrain response Dynamic mode (see 102, DYNAMIC). Automatic change up will not occur when CommandShift™ is used in Dynamic mode.
Automatic transmission
1. To select Drive (D) when the vehicle is stationary, apply the foot brake and press the gear selector release button. Note: If pressure is applied to the selector lever before the foot brake is ...Manual gear selection
When D is selected, manual mode may be temporarily accessed by operating the steering wheel mounted shift paddles. While in D, temporary manual mode will be held while the driver is accelerating, ...See also:
Vehicle Personalization
Your vehicle may have customization capabilities that allow you to program certain
features to one preferred setting.
Customization features can only be programmed to one setting on the vehicle and ...
Filling the Tank
WARNING
Fuel vapor burns violently and a fuel fire can cause bad injuries.
To help avoid injuries to you and others, read and follow all the instructions
on the fuel pump island. Turn off the engi ...
New Vehicle Break-In
Notice: The vehicle does not need an elaborate break-in. But it will perform
better in the long run if you follow these guidelines:
Keep the vehicle speed at 88 km/h (55 mph) or less for the firs ...