Range Rover: Before programing - Garage door opener - Range Rover Owner's ManualRange Rover: Before programing

NOTICE NOTICE

When programing a device that may require you to press and re-press the hand-held transmitter (cycle), unplug the device during the cycling process to prevent possible motor failure.

For best results, fit a new battery to the hand-held transmitter of the garage door opener (or other device) before programing. If your garage door opener receiver (located in the garage) is equipped with an antenna, ensure that the antenna is hanging straight down.

    Garage door transceiver
    CAUTION Do not use the transceiver with any garage door opener that lacks the safety stop and reverse feature as required by safety standards. CAUTION When programing the transceiver to ...

    Programing
    With the engine switched off; 1. Ensure that the ignition system is on. 2. Hold the end of the original garage door opener hand-held transmitter 2 to 6 inches (50 to 150 mm) away from the transc ...

    See also:

    Climate controlled seats (if so equipped)
    The climate controlled seat warms up or cools down the front seats by blowing warm or cool air from the surface of the seat. The switches located on the instrument panel can be operated inde ...

    Replacement Bulbs
    For replacement bulbs not listed here, contact your dealer. ...

    MOExtended tires (tires with run-flatproperties)
    MOExtended tires (tires with run-flat properties) allow you to continue driving your vehicle even if one or more tires are entirely deflated. MOExtended tires may be used only in conjunction wi ...