Infiniti QX: Automatic door locks
► All doors lock automatically when the
vehicle speed reaches 15 MPH (24
km/h).
► All doors unlock automatically when the
ignition switch is placed in the OFF
position.
The automatic unlock function can be
deactivated or activated. To deactivate or
activate the automatic door unlock system,
perform the following procedure:
1. Close all doors.
2. Place the ignition switch in the ON
position.
3. Within 20 seconds of performing Step
2, push and hold the power door lock
switch to the
position (UNLOCK) for
more than 5 seconds.
4. When activated, the hazard indicator
will flash twice. When deactivated, the
hazard indicator will flash once.
5. The ignition switch must be placed in
the OFF and ON position again between
each setting change.
When the automatic door unlock system is
deactivated, the doors do not unlock when
the ignition switch is placed in the OFF
position. To unlock the door manually, use
the inside lock knob or the power door lock
switch (driver’s or front passenger’s side).
Locking with power door lock switch
Operating the power door lock switch will
lock or unlock all the doors. The switches
are located on the driver’s and front
passenger’s door armrests.
To lock the doors, push the power do ...
Child safety rear door lock
Child safety rear door locks help prevent
doors from being opened accidentally,
especially when small children are in the
vehicle.
When the levers are in the lock position
1 , the rear door ...
See also:
Instrument Panel Storage
This vehicle has an instrument panel storage area (A). To open the cover, press
the button.
The vehicle may have an auxiliary input jack located on the lower right side
of the faceplate and for ...
Wheel and tire combinations
Please bear the following in mind
For safety reasons, Mercedes-Benz
recommends that you only use Tires and
wheels which have been approved by
Mercedes-Benz specifically for your
vehicle.
The ...
Checking Brake Fluid
Check brake fluid by looking at the brake fluid reservoir. See Engine Compartment
Overview .
The fluid level should be above MIN. If it is not, have the brake hydraulic system
checked to se ...






