Buick Enclave: Anti-theft Alarm System - Vehicle Security - Keys, Doors, and Windows - Buick Enclave Owner's ManualBuick Enclave: Anti-theft Alarm System

On vehicles with an anti-theft alarm system, to activate the system:

► Press (RKE) transmitter or the power door lock switch when any door is open. on the Remote Keyless Entry (RKE) transmitter or the power door lock switch when any door is open.

The security light flashes.

The security light flashes.

When the door is closed, the security light stops flashing and stays on solid for approximately 30 seconds.

The content theft-deterrent alarm is not armed until the security light goes off.

If the delayed locking feature is active, the alarm is not activated until all doors are closed and the security light goes off.

► Press The security light comes on solid for approximately 30 seconds and then goes off. when the driver door is closed. The security light comes on solid for approximately 30 seconds and then goes off.

The content theft-deterrent alarm is not armed until the security light goes off.

The theft-deterrent system will not activate if the doors are locked with the vehicle's key or the manual door lock.

If a locked door is opened without using the RKE transmitter, a 10-second pre-alarm occurs.

The horn chirps and the lights flash.

If the key is not placed in the ignition and turned to START or the door is not unlocked by pressing pre-alarm, the alarm goes off. during the 10-second pre-alarm, the alarm goes off.

The headlamps flash and the horn sounds for about 30 seconds, then turns off to save the battery power.

The vehicle can be started with the correct ignition key if the alarm has been set off.

To avoid setting off the alarm by accident:

► Lock the vehicle with the door key after the doors are closed.

► Unlock the door with the RKE transmitter. Unlocking a door any other way sets off the alarm if the system has been armed.

Press and turn it to START to turn off the alarm. or place the key in the ignition and turn it to START to turn off the alarm.

Testing the Alarm

To test the alarm:

1. From inside the vehicle, lower the driver side window, and open the driver door.

2. Press 3. Get out of the vehicle, close the door, and wait for the security light to go.
3. Get out of the vehicle, close the door, and wait for the security light to go out.
4. Reach in through the window, unlock the door with the manual door lock, and open the door.

This should set off the alarm.

If the alarm does not sound when it should, but the headlamps flash, check to see if the horn works.

The horn fuse may be blown.

To replace the fuse, see Fuses and Circuit Breakers .

If the alarm does not sound or the headlamps do not flash, see your dealer for service.

    Vehicle Security
    This vehicle has theft-deterrent features; however, they do not make it impossible to steal. ...

    Immobilizer
    See Radio Frequency Statement  for information regarding Part 15 of the Federal Communications Commission (FCC) rules and Industry Canada Standards RSS-GEN/210/220/310. ...

    See also:

    Cleaning the sensors
    NOTICE When washing the vehicle do not aim high pressure water jets directly at the sensors. Do not use abrasive materials or hard/sharp objects to clean the sensors. Only use approved vehic ...

    Cleaning the paintwork
    Scratches, corrosive deposits, areas affected by corrosion and damage caused by inadequate care cannot always be completely repaired. In such cases, visit a qualified specialist workshop, e.g. an ...

    Lower Anchor and Top Tether Anchor Locations
    Second Row — 60/40 (Lower Anchor): Seating positions with two lower anchors. (Top Tether Anchor): Seating positions with top tether anchors. For models with 60/40 second row seating, the rea ...