Infiniti QX: 4WD shift indicator
The 4WD shift indicator is displayed in the
vehicle information display.
The indicator should turn off within 1
second after placing the ignition switch in
the ON position.
While the engine is running, the 4WD shift
indicator will illuminate the position selected
by the 4WD shift switch. (See the
4WD shift procedure list shown in the
“INFINITI all-mode 4WD® system” earlier in
this section.).
► The 4WD shift indicator may blink while
shifting from one drive mode to the
other. When the shifting is completed,
the 4WD shift indicator will come on. If
the indicator does not come on immediately,
make sure the area around
the vehicle is safe, and drive the
vehicle straight, accelerate or decelerate
or move the vehicle in reverse,
then shift the 4WD shift switch.
► If the 4WD warning light comes on, the
4WD shift indicator turns off.
4WD shift switch
► Shift the 4WD shift switch to either the
AUTO, 4H or 4L position, depending on
driving conditions.
► With the switch set to the AUTO position,
distribution of torque to the front ...
4WD warning light
The 4WD warning light is located in the
meter.
The 4WD warning light comes on when the
ignition switch is placed in the ON position.
It turns off soon after the engine is
started.
If any ...
See also:
Cleaning the seat covers
Do not use microfiber cloths to clean
genuine leather, artificial leather or
Alcantara® covers. If used often, these can
damage the cover.
Observe the following when cleaning:
• clean genu ...
Fuel Gauge
When the ignition is on, the fuel gauge shows about how much fuel the vehicle
has left in the tank.
An arrow on the fuel gauge indicates the side of the vehicle the fuel door is
on.
The gauge wi ...
Opening the hood
1. Pull the hood release lever, located in the left-hand front footwell.
2. Lift the hood safety catch lever, located below the center point of the hood,
then raise the hood. ...