Buick Enclave: Wiper Blade Replacement
Windshield wiper blades should be inspected for wear or cracking.
See Maintenance Schedule for more information.
Replacement blades come in different types and are removed in different ways. To replace the wiper blade assembly:
1. Pull the windshield wiper arm away from the windshield.

2. Press the button in the middle of the wiper arm connector and pull the wiper
blade away from the arm connector.
3. Install the new wiper blade and make sure the wiper blade locks into place.
For the proper size and type see Maintenance Replacement Parts .
Backglass Wiper Blade
To replace the backglass wiper blade:
1. Pull the wiper blade assembly away from the backglass.
The backglass wiper blade will not lock in a vertical position so care should
be used when pulling it away from the vehicle.
2. Rotate the wiper blade assembly, hold the wiper arm in position, and push the
blade away from the wiper arm.
3. Replace the wiper blade.
4. Return the wiper arm and blade assembly to the rest position on the glass.
Park Brake and P (Park) Mechanism Check
WARNING
When you are doing this check, the vehicle could begin to move.
You or others could be injured and property could be damaged.
Make sure there is room in front of the vehicle in case it begi ...
Windshield Replacement
The vehicle is equipped with an acoustic windshield. If you ever have to have
the windshield replaced be sure to get an acoustic windshield so you will continue
to have the benefits an acoustic wi ...
See also:
System self-test
After you have switched on the ignition, the
system carries out a self-diagnosis.
WARNING
A malfunction in the system has been
detected if one of the following conditions
occurs:
• ...
Headlamp washers
If the headlamps are on, and there is sufficient liquid in the washer reservoir,
operating the screen wash will also power-wash the headlamps.
The headlamp power wash will operate on every fifth op ...
Headphones
The volume control for each set of headphones is adjusted on the headphones.
Press the channel selector button to cycle through available channels. Select
the channel appropriate for the required s ...






