Cadillac Escalade: When the System Does Not Seem To Work Properly - Rear Vision Camera (RVC) - Object Detection Systems - Driving and Operating - Cadillac Escalade Owner's ManualCadillac Escalade: When the System Does Not Seem To Work Properly

The RVC system might not work properly or display a clear image if:

  • The RVC is turned off. See “Turning the RVC System On or Off” earlier in this section.
  • It is dark.
  • The sun or the beam of headlamps is shining directly into the camera lens.
  • Ice, snow, mud, or anything else builds up on the camera lens. Clean the lens, rinse it with water, and wipe it with a soft cloth.
  • The back of the vehicle is in an accident, the position and mounting angle of the camera can change or the camera can be affected. Be sure to have the camera and its position and mounting angle checked at your dealer.
    RVC Location
    The camera is located above the license plate. This shows the field of view that the camera provides. A. View displayed by the camera A. View displayed by the camera B. Corners of the rear b ...

    Fuel
    ...

    See also:

    Variable voltage control system
    CAUTION ► Do not ground accessories directly to the battery terminal. Doing so will bypass the variable voltage control system and the vehicle battery may not charge completely. &# ...

    Stability control warning lamps
    The DSC warning lamp in the instrument pack illuminates briefly when the ignition is turned on. If the warning lamp flashes rapidly during driving, the system is active. A fault with the DSC sys ...

    Information about driving abroad
    Converting to symmetrical low beam when driving abroad: switch the headlamps to symmetrical low beam in countries in which traffic drives on the opposite side of the road to the country where the ...