Infiniti QX: Wheels - Cleaning exterior - Appearance and care - Infiniti QX Owner's ManualInfiniti QX: Wheels

Wash the wheels when washing the vehicle to maintain their appearance.
► Clean the inner side of the wheels when the wheel is changed or the underside of the vehicle is washed.
► Inspect wheel rims regularly for dents or corrosion. Such damage may cause loss of pressure or poor seal at the tire bead.
► INFINITI recommends that the road wheels be waxed to protect against road salt in areas where it is used during winter.

CAUTION
 Do not use abrasive cleaners when washing the wheels.

Aluminum alloy wheels

Wash regularly with a sponge dampened in a mild soap solution, especially during winter months in areas where road salt is used. Salt could discolor the wheels if not removed.

CAUTION
 Follow the directions below to avoid staining or discoloring the wheels:
► Do not use a cleaner that uses strong acid or alkali contents to clean the wheels.
► Do not apply wheel cleaners to the wheels when they are hot. The wheel temperature should be the same as ambient temperature.
► Rinse the wheel to completely remove the cleaner within 15 minutes after the cleaner is applied.

    Glass
    Use glass cleaner to remove smoke and dust film from the glass surfaces. It is normal for glass to become coated with a film after the vehicle is parked in the hot sun. Glass cleaner and a sof ...

    Chrome parts
    Clean chrome parts regularly with a nonabrasive chrome polish to maintain the finish. ...

    See also:

    Headlamp courtesy delay
    This feature operates whenever the lamps master switch is left in the Auto position (4), and the ignition is turned off. The headlamps will remain illuminated for up to 240 seconds. Note: The tim ...

    Driving Characteristics and Towing Tips
    WARNING The driver can lose control when pulling a trailer if the correct equipment is not used or the vehicle is not driven properly. For example, if the trailer is too heavy, the brakes may not ...

    Checking bulbs
    With all doors closed, apply the parking brake and push the ignition switch to the ON position without starting the engine. The following lights will come on (if so equipped): The following ...