Infiniti QX: Welcome light
To activate or deactivate the welcome light function, perform the following procedure. 1. Push the ignition switch to the ON position. 2. Open the driver’s side door. 3. Within 20 seconds after the ignition switch is pushed to the ON position, push the door open request switch on the driver’s side door handle for more than 5 seconds with the driver’s door open. 4. A chime sounds when the setting is completed. Once the welcome light function is active, the puddle light A and the passenger cabin illumination will illuminate when you approach the vehicle with the Intelligent Key (within approximately 3.3 ft (1 m) of the antenna built inside the door handles) and the following conditions are met.
► All doors are closed and locked.
► The ignition switch is in the LOCK or OFF
position.
► The Intelligent Key is outside the
vehicle.
► The puddle light operates within a set
duration.
BATTERY SAVER SYSTEM
The welcome light function will be deactivated automatically to prevent battery discharge under the following conditions. To activate the welcome light function again, unlock any door.
► If the welcome light function does not
operate within a set duration. Note that
the duration is set to 9 days as the
factory default setting.
► If the welcome light function is activated
15 consecutive times when you
approach and leave the vehicle with the
Intelligent Key without the doors being
unlocked.
Moonroof
WARNING
► In an accident you could be thrown from
the vehicle through an open moonroof.
Always use seat belts and child restraints.
► Do not allow anyone to stand up or
extend a ...
Interior lights
MAP LIGHTS
Push the button as illustrated to turn the
light on or off.
REAR PERSONAL LIGHTS
Push the button as illustrated to turn the
light on or off.
INTERIOR LIGHT CONTROL SWITCH
The ...
See also:
Programming Universal Home Remote — Fixed Code
For questions or help programming the Universal Home Remote System, call 1-866-572-2728
or go to www.learcar2u.com.
Most garage door openers sold before 1996 are Fixed Code units.
Programming a gar ...
Cockpit
1. Instrument brightness control switch
(P.2-42)
2. TRIP/RESET switch for twin trip odometer
(P.2-7)
3. Headlight, fog light and turn signal
switch
— Headlight (P.2-38)
— Turn sign ...
Storing Radio Station Presets
To set preset radio stations, do the following:
1. Press to turn the system on.
2. Press AUDIO and select the desired band (AM, FM, or XM (if equipped)).
3. Use the (tuning) knob,
, or
(Seek) ...