Buick Enclave: Washer Fluid
What to Use
When adding windshield washer fluid, be sure to read the manufacturer's instructions before use. If the vehicle will be operating in an area where the temperature may fall below freezing, use a fluid that has sufficient protection against freezing.
Adding Washer Fluid
When the windshield washer fluid reservoir is low, a WASHER FLUID LOW ADD FLUID message will be displayed on the Driver Information Center (DIC). See Washer Fluid Messages for more information.

Open the cap with the washer symbol on it. Add washer fluid until the tank is full. See Engine Compartment Overview for reservoir location.
Notice . When using concentrated washer fluid, follow the manufacturer's instructions for adding water.
► Do not mix water with ready-to-use washer fluid.Water can cause the solution to freeze and damage the washer fluid tank and other parts of the washer system.
Also, water does not clean as well as washer fluid.
► Fill the washer fluid tank only three-quarters full when it is very cold. This allows for fluid expansion if freezing occurs, which could damage the tank if it is completely full. ► Do not use engine coolant (antifreeze) in the windshield washer. It can damage the windshield washer system and paint.
Power Steering Fluid
The power steering fluid reservoir is located under the engine cover on the passenger
side of the vehicle.
See Engine Compartment Overview for reservoir location.
When to Check Power Steer ...
Brakes
This vehicle has disc brakes.
Disc brake pads have built-in wear indicators that make a high-pitched warning
sound when the brake pads are worn and new pads are needed.
The sound can come and go o ...
See also:
Rear Seat Audio (RSA) System
Vehicles with this feature allow the rear seat passengers to listen to and control
any of the music sources: radio, CD, DVD, or other auxiliary sources. The rear seat
passengers can control the same ...
Control panel for dual-zone automatic climate control
1 To set the temperature, left
2 To set climate control to automatic
3 To defrost the windshield
4 To increase the airflow
5 To direct the airflow through the defroster vents
6 To activate/deac ...
If the On Indicator is Lit for a Child Restraint
If a child restraint has been installed and the on indicator is lit:
1. Turn the vehicle off.
2. Remove the child restraint from the vehicle.
3. Remove any additional items from the seat such as bl ...






