Infiniti QX: Voltmeter - Meters and gauges - Instruments and controls - Infiniti QX Owner's ManualInfiniti QX: Voltmeter

When the ignition switch is pushed to the

When the ignition switch is pushed to the ON position, the volt meter indicates the battery voltage. When the engine is running, it indicates the generator voltage. While cranking the engine, the volt drop below the normal range. If the needle is not in the normal range (10.5 to 15.5 volt) while the engine is running, it may indicate that the charging system is not functioning properly. Have the system checked by an INFINITI retailer.

    Engine oil pressure gauge
    The gauge indicates the engine lubrication system oil pressure while the engine is running. When the engine speed is high, the engine oil pressure is also high. When it is low, the gauge ind ...

    Meter/ring illumination and needle sweep
    The ring illumination surrounding meters and gauges illuminates when the driver’s door is closed after getting into the vehicle with the Intelligent Key carried in. When the engine is starte ...

    See also:

    Using the Tire Sealant and Compressor Kit without Sealant to Inflate a Tire (Not Punctured)
    To use the air compressor to inflate a tire with air only and not sealant: If a tire goes flat, avoid further tire and wheel damage by driving slowly to a level place. Turn on the hazard warning f ...

    Tire pressures
    Never drive your vehicle if the tire pressures are incorrect. Under-inflation causes excessive flexing and uneven tire wear. This can lead to sudden tire failure. Over-inflation causes harsh ride, ...

    Important information about this manual
    You will see various symbols in this manual. They are used in the following ways: WARNING This is used to indicate the presence of a hazard that could cause death or serious personal injur ...