Infiniti QX: Treadwear
The treadwear grade is a comparative rating based on the wear rate of the tire when tested under controlled conditions on a specified government test course. For example, a tire graded 150 would wear one and one-half (1 1/2) times as well on the government course as a tire graded 100. The relative performance of tires depends upon actual conditions of their use, however, and may depart significantly from the norm due to variations in driving habits, service practices and differences in road characteristics and climate.
Uniform tire quality grading
DOT (Department Of Transportation) Quality
Grades: All passenger car tires must
conform to federal safety requirements in
addition to these grades.
Quality grades can be found where applicable ...
Traction AA, A, B and C
The traction grades, from highest to lowest,
are AA, A, B and C. Those grades
represent the tire’s ability to stop on wet
pavement as measured under controlled
conditions on specified govern ...
See also:
Distance warning function (vehicleswith DISTRONIC)
This function provides a warning from a speed
of approximately 20 mph(30 km/h), if:
• for a period of several seconds, the
distance to the vehicle in front is too short
for the speed at which yo ...
Road testing dynamometers (rolling roads)
It is essential that any dynamometer testing is carried out only by a qualified
person, familiar with the dynamometer testing and safety procedures practiced by
Land Rover Retailer/ Authorized Rep ...
Emergency key
Note: There are two designs of Smart Key, refer to the information which is relevant
to the design of Smart Key supplied with the vehicle.
A. Press emergency key release button and pull out side ...
