Buick Enclave: Tire Rotation
Tires should be rotated every 12 000 km (7,500 mi).
See Maintenance Schedule .
Tires are rotated to achieve a uniform wear for all tires.
The first rotation is the most important.
Any time unusual wear is noticed, rotate the tires as soon as possible and check the wheel alignment. Also check for damaged tires or wheels.
See When It Is Time for New Tires and Wheel Replacement .
Use this rotation pattern when rotating the tires.
If the vehicle has a compact spare tire, do not include it in the tire rotation.
Adjust the front and rear tires to the recommended inflation pressure on the Tire and Loading Information label after the tires have been rotated.
See Tire Pressure and Vehicle Load Limits .
Reset the Tire Pressure Monitor System. See Tire Pressure Monitor Operation .
Check that all wheel nuts are properly tightened. See “Wheel Nut Torque” under Capacities and Specifications .
WARNING
Rust or dirt on a wheel, or on the parts to which it is fastened, can make wheel
nuts become loose after time. The wheel could come off and cause an accident. When
changing a wheel, remove any rust or dirt from places where the wheel attaches to
the vehicle.
In an emergency, a cloth or a paper towel can be used; however, use a scraper or wire brush later to remove all rust or dirt.
Lightly coat the center of the wheel hub with wheel bearing grease after a wheel change or tire rotation to prevent corrosion or rust build-up.
Do not get grease on the flat wheel mounting surface or on the wheel nuts or bolts.
Check that the spare tire, if the vehicle has one, is stored properly. Push, pull, and then try to rotate or turn the tire. If it moves, tighten the cable. See Tire Changing .
Tire Inspection
We recommend that the tires, including the spare tire, if the vehicle has one,
be inspected for signs of wear or damage at least once a month.
Replace the tire if:
► The indicators at three ...
When It Is Time for New Tires
Factors such as maintenance, temperatures, driving speeds, vehicle loading, and
road conditions affect the wear rate of the tires.
Treadwear indicators are one way to tell when it is time for new ...
See also:
Temporary use spare wheel and tire change
If the compact spare wheel is fitted, the system will automatically recognize
the change in wheel positions. After approximately 10 minutes of driving above 18
mph (25 km/h), the message FRONT (RE ...
Reprograming a single garage door opener button
To program a device to a previously programed button:
1. Press and hold the desired pre-programed garage door opener button for at
least 20 seconds, but no longer than 30 seconds, until the indicat ...
Rear head restraints
WARNING
Adjust the head restraint so that the top of the head restraint is above the
center line of the head. An incorrectly adjusted head restraint increases the risk
of death or serious in ...