Buick Enclave: Tire Pressure Light - Warning Lights, Gauges, and Indicators - Instruments and Controls - Buick Enclave Owner's ManualBuick Enclave: Tire Pressure Light

For vehicles with the Tire Pressure Monitor System (TPMS), this light comes on

For vehicles with the Tire Pressure Monitor System (TPMS), this light comes on briefly when the engine is started. It provides information about tire pressures and the TPMS

When the Light Is On Steady

This indicates that one or more of the tires are significantly underinflated.

► Driver Information Center (DIC) tire pressure message may also display. See Vehicle Messages  for more information.

Stop as soon as possible, and inflate the tires to the pressure value shown on the Tire and Loading Information label. See Tire Pressure  for more information.

When the Light Flashes First and Then Is On Steady

If the light flashes for about a minute and then stays on, there may be a problem with the TPMS. If the problem is not corrected, the light will come on at every ignition cycle. See Tire Pressure Monitor Operation  for more information.

    Engine Coolant Temperature Warning Light
    The engine coolant temperature warning light comes on briefly when the vehicle is started. If it does not, have the vehicle serviced by your dealer. If the system is working normally, the indic ...

    Engine Oil Pressure Light
    WARNING Do not keep driving if the oil pressure is low. The engine can become so hot that it catches fire. Someone could be burned. Check the oil as soon as possible and have the vehicle service ...

    See also:

    General Towing Information
    Only use towing equipment that has been designed for the vehicle. Contact your dealer or trailering dealer for assistance with preparing the vehicle for towing a trailer. See the following trailer ...

    Underbody Maintenance
    Use plain water to flush dirt and debris from the vehicle's underbody. Your dealer or an underbody car washing system can do this. If not removed, rust and corrosion can develop. ...

    Sound
    Press CONFIG to enter the configure menu options, then press CONFIG again, repeatedly until Sound is selected or press the Sound screen button to make speaker and DSP (Digital Signal Processing) adj ...