Infiniti QX: System operation
The automatic drive positioner system will not work or will stop operating under the following conditions:
► When the vehicle speed is above 4 MPH
(7 km/h).
► When the adjusting switch for the
driver’s seat and steering column is
turned on while the automatic drive
positioner is operating.
► When the memory switch 1 or 2 is not
pushed for at least 1 second.
► When the seat, steering column and
outside mirrors have already been
moved to the memorized position.
► When no position is stored in the
memory switch.
► When the engine is started while
moving the automatic drive positioner.
► When the AT selector lever is moved
from the P (Park) position to any other
position. (However, it will not be
canceled if the switch is pushed while
the seat and steering column are
returning to the previous positions
(entry/exit function).).
► When the driver’s door remains open
for more than 45 seconds and the
ignition switch is not in the ON position.
Setting memory function
The status of the following settings can be
linked to the Intelligent Key and the
memorized settings can be available for
each Intelligent Key.
► Air conditioner system► Navigation ...
See also:
Filling the Tank
WARNING
Fuel vapor burns violently and a fuel fire can cause bad injuries. To help avoid
injuries to you and others, read and follow all the instructions on the fuel pump
island. Turn off the e ...
When to Check and Change Lubricant
It is not necessary to regularly check front axle fluid unless there is a leak
suspected or an unusual noise is heard. A fluid loss could indicate a problem. Have
it inspected and repaired. ...
Rain-sensing auto wiper system
The rain-sensing auto wiper system can
automatically turn on the wipers and
adjust the wiper speed depending on the
rainfall and the vehicle speed by using the
rain sensor located on the upp ...
