Cadillac Escalade: StabiliTrak® OFF Light - Warning Lights, Gauges, and Indicators - Instruments and Controls - Cadillac Escalade Owner's ManualCadillac Escalade: StabiliTrak® OFF Light

This light comes on briefly while starting the engine.

This light comes on briefly while starting the engine.

If it does not, have the vehicle serviced by your dealer. If the system is working normally, the indicator light then goes off.

Press and release the Traction Control System (TCS)/StabiliTrak button to turn off TCS, and a message displays in the DIC.

Press and briefly hold the TCS/StabiliTrak button to turn off the StabiliTrak system; the StabiliTrak Off light comes on and a message appears in the Driver Information Center (DIC).

If the StabiliTrak/TCS system is off, the system does not assist in controlling the vehicle. Turn on the StabiliTrak/TCS system and the indicator light turns off.

See StabiliTrak® System  , and Ride Control System Messages   for more information.

    Tow/Haul Mode Light
    For vehicles with the Tow/Haul Mode feature, this light comes on when the Tow/Haul Mode has been activated. For more information, see Tow/Haul Mode  . ...

    Traction Control System (TCS)/StabiliTrak® Light
    The TCS/StabiliTrak light comes on briefly when the engine is started. If the light does not come on or stays on, have the vehicle serviced by the dealer. If the system is working normally, the in ...

    See also:

    Rear
    The 2nd row outboard seats are warmed by built-in heaters. The switches located on the back side of the center console can be operated independently of each other. 1. Start the engine. ...

    Auxiliary Devices
    The vehicle may have a 3.5mm (1/8 in) auxiliary input jack located on the lower right side of the faceplate and for vehicles with a USB port, it is located in the instrument panel storage area. ...

    Front Wiper Blade Replacement
    1. Pull the windshield wiper arm connector away from the windshield. 2. Squeeze the grooved areas on each side of the blade, and turn the blade assembly away from the arm connector. 3. Install ...