Buick Enclave: Safety Belt Reminders
Driver Safety Belt Reminder Light
There is a driver safety belt reminder light on the instrument panel cluster.
When the vehicle is started, this light flashes and a chime may come on to remind the driver to fasten their safety belt. Then the light stays on solid until the belt is buckled.
This cycle may continue several times if the driver remains or becomes unbuckled while the vehicle is moving.
If the driver safety belt is buckled, neither the light nor the chime comes on.
Passenger Safety Belt Reminder Light
When the vehicle is started, this light flashes and a chime may come on to remind front passengers to fasten their safety belt. Then the light stays on solid until the belt is buckled.
This cycle continues several times if the front passenger remains or becomes unbuckled while the vehicle is moving.
If the front passenger safety belt is buckled, neither the chime nor the light comes on.
The front passenger safety belt reminder light and chime may turn on if an object is put on the seat such as a briefcase, handbag, grocery bag, laptop, or other electronic device. To turn off the reminder light and/or chime, remove the object from the seat or buckle the safety belt.
Voltmeter Gauge
When the engine is not running, but the ignition is on, this gauge shows the
battery's state of charge in DC volts.
When the engine is running, this gauge shows the condition of the charging ...
Airbag Readiness Light
This light shows if there is an electrical problem. The system check includes
the airbag sensor(s), passenger sensing system, the pretensioners, the airbag modules,
the wiring, and the crash sensi ...
See also:
Recovery Hooks
WARNING
Never pull on recovery hooks from the side. The hooks could break and you and
others could be injured. When using recovery hooks, always pull the vehicle straight
out.
Notice: Never ...
Ignition Positions
The ignition switch has four different positions.
To shift out of P (Park), the ignition must be in ON/RUN or ACC/ ACCESSORY and
the regular brake pedal must be applied.
A (STOPPING THE ENGINE/ L ...
Stationary range changing
With the vehicle stationary, select N.
Move the transfer gearbox switch towards the range required and release. The
switch returns to the default position and range change status will be confirmed ...