Cadillac Escalade: Programming the Power Windows
If the battery on the vehicle has been recharged, disconnected, or is not working, you will need to reprogram each front power window for the express-up feature to work. Before reprogramming, replace or recharge the vehicle's battery.
To program each front window, follow these steps:
1. With the ignition in ACC/ ACCESSORY, ON/RUN, or when RAP is active, close all doors.
2. Press and hold the power window switch until the window is fully open.
3. Pull the power window switch up until the window is fully closed.
4. Continue holding the switch up for approximately two seconds after the window is completely closed.
The window is now reprogrammed. Repeat the process for the other windows.
Express Window Anti-Pinch Override
WARNING
If express override is activated, the window will not reverse automatically.
You or others could be injured and the window could be damaged. Before you use express
override, make sure t ...
Window Lockout
This feature prevents the rear passenger windows from operating, except from
the driver position.
Press to activate the rear
window locks. An indicator light will illuminate when the feature ...
See also:
How the System Works
URPA comes on automatically when the shift lever is moved into R (Reverse). A
single tone sounds to indicate the system is working.
URPA operates only at speeds less than 8 km/h (5 mph).
An obstacl ...
Power Outlets
The vehicle has 12-volt outlets that can be used to plug in electrical equipment,
such as a cell phone or MP3 player.
The power outlets are located on the instrument panel below the climate control ...
Ashtray in the rear-compartment centerconsole
Close the ashtray when it is not in use and
before you fold the rear seats forward. You
can otherwise damage the ashtray.
► To open: briefly press marking 2.
Ashtray 2 opens.
► ...
