Buick Enclave: Parking Brake - Brakes - Driving and Operating - Buick Enclave Owner's ManualBuick Enclave: Parking Brake

To set the parking brake, hold the regular brake pedal down, then push the parking

To set the parking brake, hold the regular brake pedal down, then push the parking brake pedal down.

If the ignition is on, the brake system warning light will come on.

See Brake System Warning Light .

Notice: Driving with the parking brake on can overheat the brake system and cause premature wear or damage to brake system parts. Make sure that the parking brake is fully released and the brake warning light is off before driving.

To release the parking brake, hold the regular brake pedal down, then push down momentarily on the parking brake pedal until you feel the pedal release. Slowly pull your foot up off the park brake pedal.

If the parking brake is not released when you begin to drive, the brake system warning light will be on and a chime will sound warning you that the parking brake is still on.

If you are towing a trailer and are parking on a hill, see Driving Characteristics and Towing Tips .

    Antilock Brake System (ABS)
    This vehicle has the Antilock Brake System (ABS), an advanced electronic braking system that helps prevent a braking skid. When the engine is started and the vehicle begins to drive away, ABS check ...

    Brake Assist
    This vehicle has a brake assist feature designed to assist the driver in stopping or decreasing vehicle speed in emergency driving conditions. This feature uses the stability system hydraulic brak ...

    See also:

    Windshield Replacement
    The vehicle is equipped with an acoustic windshield. If you ever have to have the windshield replaced be sure to get an acoustic windshield so you will continue to have the benefits an acoustic wi ...

    Maintenance Schedule
    Owner Checks and Services At Each Fuel Stop . Check the engine oil level. See Engine Oil  . Once a Month . Check the tire inflation pressures. See Tire Pressure  . . Inspect the tires f ...

    Battery Replacement
    To change the remote control batteries: 1. Slide the rear cover back on the remote control. 2. Replace the two batteries in the compartment. Make sure they are installed correctly using the diagram ...