Cadillac Escalade: Navigation Control Buttons
The following control buttons are located on the navigation system:
(Power/Volume):
1. Press to turn the system on and off.
2. Turn to increase or decrease the volume to the audio system.
3. Press and hold for more than two seconds to turn off the navigation system, the Rear Seat Entertainment (RSE), and Rear Seat Audio (RSA). If the vehicle has not been tuned off, the RSE and the RSA can be turned back on by pressing this knob and continues play of the last active source.
(Eject): Press to eject the CD/DVD
Disc. See CD/DVD Player .
(Tuning Knob): Turn to go to the
next or previous frequency or disc track or chapter. See CD/DVD Player
or MP3 for more information.
AUDIO: Press to display the audio screen. Press to switch between AM, FM, or XM, if equipped, DISC, or AUX (Auxiliary), or press on the screen button. See CD/DVD Player , MP3 , and Auxiliary Devices for more information.
FAV (Favorite): Press to access the preset stations. See “Storing Radio Station Presets” under, Overview .
(Phone): See OnStar Overview (if equipped) and Bluetooth (if equipped) for more information.
(Sound): Press to access the Sound
menu to adjust the treble, midrange, bass, fade, balance, and Digital Signal Processing
(DSP).
(Scan Up/Down): Press to scan the
tracks/chapters up or down on a disc.
or
(Seek/Scan) (Previous/Next): Press
the up or down arrows to go to the next or previous station. Press and hold either
arrow for more than two seconds. The radio goes to a station, plays for a few seconds,
then goes to the next station.
NAV (Navigation): Press to view the vehicle's current position on the map screen. Each press of this button cycles through Full Map and the tab that displays the current audio source (AM, FM, XM (if equipped), CD, etc.). Full Map displays the screen in full map view. Selecting the audio tab splits the screen between the map screen and the current audio source screen menu.
RPT (Repeat): Press to repeat the last voice guidance prompt.
DEST (Destination): Press to access the Destination Entry screen. From this screen, you can select from several options to plan a route by entering destination points.
CONFIG (Configure): Press to adjust several of the system's features and preferences.
Using the Navigation System
This section presents basic information needed to operate the navigation system.
Use the buttons located on the navigation system along with the available touch-sensitive
screen buttons on the navig ...
Touch-Sensitive Screen Buttons
Touch-sensitive screen buttons are located on the screen. When a screen button
has been selected, a beep sounds. Screen buttons are highlighted when a feature
is available. ...
See also:
Switching on DISTRONIC, storing andmaintaining the current speed
WARNING
The vehicle can be braked when DISTRONIC
is activated. For this reason, deactivate
DISTRONIC if the vehicle is to be set in motion
by other means (e.g. in a car wash or by
tow ...
Overview: changing bulbs/bulb types
You can change the following bulbs. The bulb
type can be found in the legend.
Halogen headlamps
1 Low-beam headlamp: H7 55 W
2 High-beam headlamp: H7 55 W
3 Parking lamp/standing lamp: W 5 W
4 ...
Battery Load Management
The vehicle has Electric Power Management (EPM) that estimates the battery's
temperature and state of charge. It then adjusts the voltage for best performance
and extended life of the battery.
...