Buick Enclave: Engine Oil Life System
The engine oil life system calculates engine oil life based on vehicle use and displays the CHANGE ENGINE OIL SOON message when it is time to change the engine oil and filter.
The oil life system should be reset to 100% only following an oil change.
Resetting the Oil Life System
1. Turn the ignition to ON/RUN, with the engine off.
2. Press the vehicle information button until OIL LIFE REMAINING displays.
3. Press and hold the set/reset button until “100%” is displayed.
Three chimes sound and the CHANGE ENGINE OIL SOON message goes off.
4. Turn the key to LOCK/OFF.
See Engine Oil Life System .
Tire Sealant and Compressor Kit
This vehicle may come with a spare tire and tire changing equipment or a tire
sealant and compressor kit.
The kit can be used to temporarily seal small punctures in the tread area of
the tire.
S ...
Driving for Better Fuel Economy
Driving habits can affect fuel mileage. Here are some driving tips to get the
best fuel economy possible.
► Avoid fast starts and accelerate smoothly.
► Brake gradually and avoid abrup ...
See also:
Radio
Press CONFIG to enter the configure menu options, then press CONFIG again, repeatedly
until Radio is selected or press the Radio screen button to make changes for radio
information displayed, preset ...
Removing the Spare Tire and Tools
The equipment needed to change a flat tire is stored under the storage tray,
located on the driver side trim panel, over the rear wheelhouse.
Regular Wheelbase Shown, Extended Wheelbase Similar.
...
Vehicle-to-vehicle distance control mode operation
Always pay attention to the operation of
the vehicle and be ready to manually
control the proper following distance. The
vehicle-to-vehicle distance control mode of
the Intelligent Cruise Co ...
