Range Rover: Dynamic stability control (DSC) (Amber)
Illuminates briefly as a bulb check when the ignition is switched on.
If the lamp flashes while driving, the DSC system is active. If the lamp illuminates continuously while driving, there is a fault with the DSC system. The vehicle can still be driven, but the DSC system will not activate under wheel spin or slide conditions. Seek qualified assistance as soon as possible.
Brake (amber)
USA.
Canada.
Illuminates briefly as a bulb check when the ignition is switched on. If the
lamp illuminates after starting the engine or while driving, suspect worn brake
pads ...
Dynamic stability control (DSC) OFF (Amber)
Illuminates when DSC is switched off. ...
See also:
Selecting off-road height
Off-road height can be selected by pressing up on the raise/lower switch (1)
at any speed up to 24 mph (40 km/h). If selected, and the speed exceeds 30 mph (50
km/h), a warning will appear in the ...
Rear towing point
The rear towing point is located behind a removal panel in the lower rear bumper.
The rear towing point may be used to tow another vehicle if required.
1. Rotate each of the fasteners 90 degrees ...
Using ACC
1. SET+: Press to increase or set the speed.
2. Press to resume the set speed.
3. Press to decrease the set speed.
4. CAN: Cancels, but retains the set speed in memory.
5. Press to decrease the ...
