Buick Enclave: Connecting a USB Storage Device or iPod®
To connect a USB storage device, connect the device to the USB port located in the instrument panel storage area. See Instrument Panel Storage for more information.
The USB port can be used to control an iPod or a USB storage device.
To connect an iPod, connect one end of the USB cable that came with the iPod to the iPod’s dock connector, and connect the other end to the USB port located in the instrument panel storage area.
If the vehicle is on and the USB connection works, “OK to disconnect” and a GM logo may appear on the iPod, and iPod appears on the radio's display.
The iPod music appears on the radio’s display and begins playing.
The iPod charges while it is connected to the vehicle if the vehicle is in the ACC/ACCESSORY or ON/RUN position. When the vehicle is turned off, the iPod automatically powers off and will not charge or draw power from the vehicle's battery.
If you have an older iPod model that is not supported, it can still be used by connecting it to the auxiliary input jack using a standard 3.5 mm (1/8 in) stereo cable. See Auxiliary Devices for more information.
Playing an MP3/WMA File From a Disc (In Either the DVD or CD Slot)
If a disc is inserted into the top DVD slot, the rear seat operator can turn
on the video screen and use the remote control to navigate the CD (tracks only).
(Tune): Turn to select MP3/WMA files.
...
Using the Radio to Control a USB Storage Device or iPod
The radio can control a USB storage device or an iPod using the radio buttons
and knobs and display song information on the radio’s display.
(Tune): Turn to select files.
SEEK: Press to go to ...
See also:
How the occupant classificationsystem works
The OCS is standard equipment in the USA.
The OCS categorizes the occupant on the
front-passenger seat by means of a weight
sensor. The front-passenger front air bag is
deactivated automatically ...
Clearing the programmed information
Individual buttons cannot be cleared,
however to clear all programming, push
and hold the two outside buttons and
release when the indicator light begins to
flash (in approximately 20 seconds) ...
Battery Replacement
To change the batteries on the headphones:
1. Turn the screw to loosen the battery door located on the left side of the
headphones.
Slide the battery door open.
2. Replace the two batteries in th ...
