Buick Enclave: Clock - Controls - Instruments and Controls - Buick Enclave Owner's ManualBuick Enclave: Clock

To adjust the time and date:

1. Turn the ignition key to ACC/ACCESSORY or ON/RUN, then press 2. Press to display HR, MIN, MM, DD, to turn the radio on.
2. Press YYYY (hour, minute, month, day, and year). to display HR, MIN, MM, DD, YYYY (hour, minute, month, day, and year).
3. Press the pushbutton located under any one of the labels to be changed.
4. To increase the time or date, do one of the following:

► Press the pushbutton below the selected label.

► Press ► Press FWD. SEEK.

► Press ► Turn clockwise. FWD.

► Turn 5. To decrease the time or date, do one of the following: clockwise.

5. To decrease the time or date, do one of the following:

► Press ► Press REV. SEEK.

► Press ► Turn counterclockwise. REV.

► Turn To change the time default setting from 12 hour to 24 hour or to change the date counterclockwise.

To change the time default setting from 12 hour to 24 hour or to change the date default setting from month/day/year to day/month/year:

1. Press located under the forward arrow that displays on the radio screen until the time and then the pushbutton located under the forward arrow that displays on the radio screen until the time 12H (hour) and 24H (hour), and the date MM/DD (month and day) and DD/MM (day and month) display.
2. Press the pushbutton located under the desired option.
3. Press default, or let the screen time out. again to apply the selected default, or let the screen time out.

    Compass
    Your vehicle may have a compass in the Driver Information Center (DIC). See Driver Information Center (DIC)  for more information about the DIC. Compass Zone The zone is set to zone eight upo ...

    Power Outlets
    The vehicle has 12-volt outlets that can be used to plug in electrical equipment, such as a cell phone or MP3 player. The power outlets are located on the instrument panel below the climate control ...

    See also:

    Power Steering Fluid
    See Engine Compartment Overview   for reservoir location. ...

    Map Coordinates
    The coordinates destination entry method lets you select a destination by entering latitude and longitude coordinates. Map Coordinates: Press to access the Coordinates Entry screen. To use the co ...

    Cleaning the wiper blades
    WARNING   Before cleaning the windshield or wiper blades, switch off the windshield wipers and remove the SmartKey from the ignition lock. On vehicles with KEYLESS-GO, press the Start/S ...