Infiniti QX: Clearing the programmed information
Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds).
Programming trouble-diagnosis
If HomeLink® does not quickly learn the
hand-held transmitter information:
► replace the hand-held transmitter batteries
with new batteries.
► position the hand-held transmitter w ...
Reprogramming a single HomeLink® button
To reprogram a HomeLink® Universal
Transceiver button, complete the following.
1. Push and hold the desired HomeLink®
button. Do not release the button until
step 4 has been completed.
2. ...
See also:
How to use STATUS button
To display the status of the audio, air
conditioner system, fuel consumption and
navigation system, push the STATUS button.
The following information will appear
when the STATUS button is push ...
Hitch Cover (with Dual Exhaust)
To remove the hitch cover:
1. Turn the fasteners on the lower tabs 90 degrees counterclockwise.
2. Pull the lower edge of the cover out slightly.
3. Lift the cover up off the upper bracket.
To r ...
If the Vehicle Is Stuck
Slowly and cautiously spin the wheels to free the vehicle when stuck in sand,
mud, ice, or snow. See “Rocking Your Vehicle to Get It Out” later in this section.
If the vehicle has a traction sys ...
