Range Rover: Changing the cruise speed - Cruise control - Range Rover Owner's ManualRange Rover: Changing the cruise speed

Range Rover / Range Rover Owner's Manual / Cruise control / Changing the cruise speed

Decreasing speed

To decrease the cruising speed, press and hold the - switch (3). Release the switch when the desired speed is reached, the new speed will be set and maintained.

The set speed can be decreased in steps of 1 mph (2 km/h) by briefly pressing the - switch.

Increasing speed

Press and hold the SET+ switch (1) to increase cruising speed. Release the switch when the desired speed is reached, the new speed will be set and maintained.

Cruising speed can also be increased using the accelerator. When the desired speed is reached, press the SET+ switch to set and maintain the new speed, and release the accelerator.

The set speed can be increased in steps of 1 mph (2 km/h) by briefly pressing the SET+ switch.

    Setting vehicle speed
    WARNING The driver must always ensure that a safe speed is maintained within the speed limit, taking account of traffic and road conditions. Do not use cruise control in heavy traffic or con ...

    See also:

    Overheated Engine Protection Operating Mode
    If an overheated engine condition exists and the ENGINE POWER IS REDUCED message is displayed, an overheat protection mode which alternates firing groups of cylinders helps prevent engine damage. In ...

    Sunroof
    A. Open or Close B. Vent On vehicles with a sunroof, the sunroof only operates when the ignition is in the ACC/ACCESSORY or ON/RUN, or when Retained Accessory Power (RAP) is active. See Retained ...

    Service messages
    Information on the type of service and service intervals (see separate Service Booklet). You can obtain further information from an authorized Mercedes-Benz Center or at http://www.mbusa.com (US ...