Infiniti QX: Car phone or CB radio - Monitor, climate, audio, phone and voice recognition systems - Infiniti QX Owner's ManualInfiniti QX: Car phone or CB radio

When installing a car phone or a CB radio in your vehicle, be sure to observe the following cautions, otherwise the new equipment may adversely affect the electronic control modules and electronic control system harness.

► A cellular phone should not be used for WARNING

► A cellular phone should not be used for any purpose while driving so full attention may be given to vehicle operation. Some jurisdictions prohibit the use of cellular phones while driving.
► If you must make a call while your vehicle is in motion, the hands-free cellular phone operational mode (if so equipped) is highly recommended. Exercise extreme caution at all times so full attention may be given to vehicle operation.
► If a conversation in a moving vehicle requires you to take notes, pull off the road to a safe location and stop your vehicle before doing so.

CAUTION
► Keep the antenna as far away as possible from the electronic control modules.
► Keep the antenna wire more than 8 in (20 cm) away from the electronic control system harness. Do not route the antenna wire next to any harness.
► Adjust the antenna standing-wave ratio as recommended by the manufacturer.
► Connect the ground wire from the CB radio chassis to the body.
► For details, consult an INFINITI retailer.

    Care and maintenance
    Use a lightly dampened, lint free cloth to clean the surfaces of your Dual Head Restraint DVD System (DVD player face, screen, remote controller, etc.). CAUTION ► Do not use any solve ...

    Bluetooth® Hands-Free Phone System
    WARNING ► Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may be given to ...

    See also:

    Using the system
    Initialization When the ignition switch is pushed to the ON position, INFINITI Voice Recognition is initialized, which may take up to one minute. When completed, the system is ready to accept ...

    High-Beam On Light
    The high-beam on light comes on when the high-beam headlamps are in use. See Headlamp High/Low-Beam Changer  for more information. ...

    Service Parts Identification Label
    This label, on the inside of the glove box, has the following information: Vehicle Identification Number (VIN). Model designation. Paint information. Production options and special equipment ...