Infiniti QX: Capacities and recommended fuel/lubricants
The following are approximate capacities. The actual refill capacities may be a little different. When refilling, follow the procedure instructed in the “8. Maintenance and do-it-yourself” section to determine the proper refill capacity.

1: For additional information, see “Engine oil” in the “8. Maintenance and
do-it-yourself” section for changing engine oil.
2: For additional information, see “Engine oil and oil filter recommendation”
later in this section.
3: INFINITI recommends Genuine NISSAN Ester Engine Oil available at INFINITI
retailers.
4: Using automatic transmission fluid other than Genuine NISSAN Matic S ATF
will cause deterioration in driveability and automatic transmission durability,
and may damage the automatic
transmission, which is not covered by the INFINITI new vehicle limited warranty.
5: Using transfer fluid other than Genuine NISSAN Transfer Fluid will damage
the transfer, which is not covered by the INFINITI new vehicle limited warranty.
6: For hot climates, Viscosity SAE 90 is suitable for ambient temperatures
above 328F (08C).
7: See an INFINITI retailer for service for synthetic oil.
8: DEXRONTM VI type ATF may also be used.
9: Available in mainland US through an INFINITI retailer.
10: Using Hydraulic Suspension fluid other than Genuine NISSAN Hydraulic
Suspension fluid will damage the Hydraulic Suspension, which is not covered by
the INFINITI new vehicle limited warranty.
See an INFINITI retailer for recommended hydraulic suspension fluid.
11: For additional information, see “Vehicle identification” later in this
section for air conditioner specification label.
- Fuel recommendation
- Engine oil and oil filter recommendation
- Air conditioning system refrigerant and lubricant recommendations
Fuel recommendation
VK56VD engine
INFINITI recommends the use of unleaded
premium gasoline with an octane rating of
at least 91 AKI (Anti-Knock Index) number
(Research octane number 96).
If unleaded premium gaso ...
See also:
Using RSE
The system is operated using the remote control.
To release the remote from the docked position, press at the top of the remote
to unlatch it.
NOTICE
Do not attempt to pull the remote contro ...
Resuming the speed and follow mode
NOTICE
RESUME should only be used if the driver is aware of the set speed and intends
to return to it.
By pressing the RESUME button after ACC has been cancelled (e.g. after braking),
the A ...
Environmental factors influence the rate of corrosion
Moisture
Accumulation of sand, dirt and water on
the vehicle body underside can accelerate
corrosion. Wet floor coverings will not dry
completely inside the vehicle, and should
be removed for ...







