Range Rover: Before programing - Garage door opener - Range Rover Owner's ManualRange Rover: Before programing

NOTICE NOTICE

When programing a device that may require you to press and re-press the hand-held transmitter (cycle), unplug the device during the cycling process to prevent possible motor failure.

For best results, fit a new battery to the hand-held transmitter of the garage door opener (or other device) before programing. If your garage door opener receiver (located in the garage) is equipped with an antenna, ensure that the antenna is hanging straight down.

    Garage door transceiver
    CAUTION Do not use the transceiver with any garage door opener that lacks the safety stop and reverse feature as required by safety standards. CAUTION When programing the transceiver to ...

    Programing
    With the engine switched off; 1. Ensure that the ignition system is on. 2. Hold the end of the original garage door opener hand-held transmitter 2 to 6 inches (50 to 150 mm) away from the transc ...

    See also:

    California Fuel Requirements
    If the vehicle is certified to meet California Emissions Standards, it is designed to operate on fuels that meet California specifications. See the underhood emission control label. If this fuel is ...

    DOT, Tire Identification Number (TIN)
    U.S. tire regulations prescribe that every manufacturer of new tires or retreader has to imprint a TIN in or on the sidewall of each tire produced. The TIN is a unique identification number. The ...

    Changing from low to high range
    With the vehicle traveling no faster than 38 mph (60 km/h), select N. Press the front of the transfer gearbox switch to select Hi. Indication of the range change status is the same as for the stati ...